Harmonia

Dual channel electrical thermal control of SUBs and SUFs and SUMs

Dual channel thermal controller for cultivation, fermentation or mixing of liquids in size 0.2 - 50 litre Vessel Volume. Such as the CellVessel SUBs or Bactovessel SUFs or CellMiscelatore SUMs from www.cercell.com or CP-SUBs from www.prolifecell.com or P-SUBs from www.perfusecell.com

Product, model name

Harmonia

Purpose

Thermal control

Hephaestus cabinet size

U2

Degree resolution

15 bit - 0,03 °C

Power supply - in/out

110 - 230 VAC, 10 amp

Weight, kilo

3,5

Design

Dual independent channel controller with build-in Apollon PLC. Harmonia can operate in a stand-alone setup, autonomous or chained with other Cronus components or other PCS via OPC-UA. Designed for electrical elements operating at either 110 or 230 VAC. Elements can be heating rods or flexible blankets of same voltage as supply voltage. Power control with Solid-State-Relay (SSR) for very long lifetime. 

Models from 2021 include on both channels the feature to measure if a thermal element consume power or not. As if not mounted, connected, broken, thermo couple problems, lack of liquids, etc. And thus give extra security and info that a check-up may be needed. 

Harmonia in U2 Hephaestus Stainless Steel cabinet. Shown with thermal control devices: Heating-Support-Foot (HSF) for 500 ml SUB, SUM and Heating-Support-Foot (HSF) for the 3.2 liter SUB, SUM. The far right photo show the orange Electrical-Heating-Blanket (EHB) and the empty shining Heating-Support-Foot (HSF) .

In & Out electrical features - front panel mounted

  • 1 x 110 - 230 VAC power inlet, IEC standard male with ground, fuse tray, red button breaker, max 10 amp
  • 2 x 110 - 230 VAC controlled power outlet, IEC standard female with ground – one each channel, max 10 amp in total
  • 2 x Pt100 sensor connection with 4 leg M12/RKF socket
  • 1 x USB socket
  • 1 x RJ45 socket

Communication

  • Internal 5” touch sensitive TFT display hooked on the Apollon PLC
  • External connection to PC, PADs or smart-Phones via Wi-Fi for programming and info from the built-in webserver
  • USB for Wi-Fi antenna and for software upgrades and data acquisition
  • RJ45 port for LAN, ModBus, OPC-UA via IP/TCP and for firmware upgrades and data acquisition

Programming

Harmonia is unique with its adaptive tuning software calculating the best suitable PID values for thermal control. The 3 PID parameters are fully accessible and free for programming for very special requirement. Compensating for the thermal mass of any system (PID = Proportional, Integral and Derivative influence).

Supplied with:

  • 2 x Pt100 sensors (one of the dimensions: OD2x100, OD2x150, OD3x200, OD3x250, OD5x350 mm with integrated M12 RKF connector)
  • 2 x thermo couple cable with M12 RKF connector in each end
  • No Electrical-Heating-Blanket or Heating-Support-Foot or Cooling-Support-Foot included - choose your desired extras

Supplied with two Platinum thermo couples of the size that fits your purpose. The far right photo show the orange Electrical-Heating-Blanket (EHB) and the shining Heating-Support-Foot (HSF) mounted with a 3.2 liter SUB.

Extras to choose from:

Communication – check out specific folder on this subject under Support
Price, availability and p/n – look under Commerce